Vatech PaX-i3D

PaX-i3D Green (PHT-60CFO) User Manual
128
9 Troubleshooting
9 Troubleshooting
If a problem occurs while operating this equipment, perform the corresponding
troubleshooting measure outlined in the table below. If the problem persists,
please contact our customer support staffs.
- If the device is not moving
Cause Solution
Power failure
Check the equipment’s power supply.
Initialization status
Wait until the equipment has initialized and then try
again.
Control PC
connection failure
Check the connection status of Serial Port (RS232)
which connects the PC to the equipment.
- If the exposure switch is not functioning
Cause Solution
Ready status
Check whether it is ready for capturing at the
imaging program.
- If imaging cannot be performed
Cause Solution
Initialization status
Wait until the equipment has initialized and then try
again. If this problem persists, restart the equipment.
- If the laser beam has shut off and patient alignment cannot be performed
Cause Solution
The time allotted for
patient alignment
has expired
Press the laser beam button to turn on the lasers
and then carry out patient alignment.
CAUTION
Do not allow any liquids in the vicinity of the machine as
moisture may cause extensive damage to this equipment’s
electrical components.
WA
RNIN
G
If a problem occurs during image acquisition, press the
red emergency stop switch to immediately stop all moving
parts and cut off all power to the equipment’s electrical
components. You may then safely release the patient from
the equipment.
[PI3DG_130U_44A_en]User Guide.indd 128 2016-05-24 오후 4:19:14