PaX-i3D Green (PHT-60CFO) User Manual
131
10 Cleaning and Maintenance
10.2
Maintenance
VATECH requires periodic constancy tests to ensure image quality and the
safety for the patient and operator.
Only VATECH authorized technicians can perform inspection and service of
this equipment. For the technical assistance, contact VATECH service center or
your local VATECH representative.
10.2.1 Regular Maintenance
There are no user serviceable parts inside this equipment.
If servicing is required, please contact the VATECH service
center or your local VATECH representative.
RNIN
- Always turn off the equipment before performing any
maintenance.
- Never remove equipment covers. There are no repairable
parts inside.
- The only part that can be replaced by the user is the
input fuses, which must comply with the manufacturer’s
specication.
- In order to safeguard against re, only replace fuses with
fuses of the same type and range.
■
Do not use force to unplug cables.
■
Do not expose the equipment or components in an area which is susceptible
to water or humidity.
■
Do not expose the equipment in an area which subject to temperature
extremes, poor ventilation, direct sun light, dust, salt, etc.
■
Keep all detachable components well organized and clean.
■
Make sure that the equipment is well grounded.
■
Never try to modify this equipment, including the wires or cables. Modifying
this equipment may damage it beyond repair.
[PI3DG_130U_44A_en]User Guide.indd 131 2016-05-24 오후 4:19:14
To Next Page
Loading...
Need help?
General
