Initial Setup Of The Console Using Workflow Wizard Setup>Communication>IFSF
16
Setup>Communication>IFSF
This screen lets you configure communication based on International Forecourt Standards
Forum (IFSF) standards for a TLS over TCP/IP or a LonWorks
®
card (LON Module). These
international standards for petroleum retail facilitate the interoperability of service stations
and equipment.
NOTE: A single console cannot support both TCP/IP and LON Module communications simul-
taneously, even though a site may have a mixed configuration on different consoles. The
maximum number of tanks a site can support is 30.
Configured
Touch the radio button to enable or disable IFSF communication.
Device
The device used for communication. Choices are: LON Module (if installed) or Eth1 for Ether-
net Port 1 (for TCP/IP), depending on your hardware configuration.
NOTE: On the TLS450PLUS, Ethernet Ports 2a and 2b are not available for IFSF configuration.
Protocol
The protocol used for IFSF. The choice is: IFSF-China1. This
field is not available with the LON Module device option.
Node Id
The ATG Node Identifier. Each IFSF tank gauge present on a
network must have a unique node ID. The default is 01, but
you can change it as required. This field is not available with
the LON Module device option.
NOTE: With a LonWorks
®
card, the Node ID is set using the
IFSF Node Address Dip Switch on the IFSF Interface Module
during installation. Refer to the Console Troubleshooting
section of the TLS-450PLUS Troubleshooting manual (P/N
577014-075) or the Troubleshooting section of the TLS4 /
8601 Series Consoles Troubleshooting manual (P/N 577014-
058), as appropriate, for more information on IFSF module
cable connector assembly and Node ID switch settings.
UDP Port
The port used for User Datagram Protocol (UDP) communi-
cation. The default is 3486, but this field can be edited if you
need to use a different port (1024-65535). This field is not
available with the LON Module device option.
TCP Port
The port used for Transmission Control Protocol (TCP) con-
nection requests. The default is 9000, but this field can be
edited if you need to use a different port (1024-65535). This
field is not available with the LON Module device option.
System Status
07/07/2016 09:10 AM
0 Warning(s)
0 Alarms(s)
Print (0)
Exit
Actions
Previous
Next
Setup
EnabledConfigured Disabled
Device
LON Module
Communication IFSF
Node Id
01
UDP Port
3485
TCP Port
9000
To Next Page
Loading...
