21
Operations & Maintenance Manual: Setting Up
0900‑5005 REV‑00
SETTING UP
To help you get started, these topics explain how to assemble the system:
1. Perform the Initial Inspection
2. Assemble the Workstation and Attach the System
3. Insert a Battery
4. Charge the Battery
5. Install the Printer (Optional)
Once the system is assembled, you can configure user settings and add custom information:
6. Configure General Settings
7. Configure Administrative Settings
8. Configure Exam Settings
9. Configure Printed and PDF Report Settings
10. Customize Cost Savings Calculations
11. Configure a PIN for Saved Exams
12. Configure a PIN for System Settings
ASSEMBLING THE SYSTEM
PROCEDURE 1. PERFORM THE INITIAL INSPECTION
When you receive the system, Verathon recommends that an operator familiar with the system perform a full
visual inspection for any physical damage that may have occurred during shipment.
1. Carefully open the top of the shipping box. Do not insert anything sharp through the box.
2. Remove the contents and verify that you have received the appropriate components for your system.
3. Inspect the components for damage.
4. If any of the components are missing or damaged, notify the carrier and Verathon CustomerCare or your
local representative.
To Next Page
Loading...
Need help?
General
