43
Operations & Maintenance Manual: Using the System
0900‑5005 REV‑00
2. If you want to rescan the patient, on the Results screen, tap Scan.
Repeat the scanning procedure as necessary to adjust your aim or confirm the initial measurement.
3. When you are finished scanning, you can review the results in B or C modes. (C‑mode is displayed by
default.) You can save scan results, and you can print scan results if you have the printer installed.
VIEW B‑MODE IMAGES
4. If B‑mode images are activated on your system and you want to view them, tap the B‑mode icon .
Dual‑pane B‑mode images of the scan appear.
5. In the top‑left corner of each of the B‑mode images, the line through the human figure icon indicates
the currently displayed plane. To navigate through the scan planes, tap the Previous and Next
icons below the images.
VIEW MULTIPLE SCANS
When you perform more than one scan, the Results screen displays the largest volume obtained. Above the
largest volume measurement, the screen indicates the most recent scan volume.
Note: If you scan the patient more than five times during a single exam, the system stores only the five latest
scan volumes.
To Next Page
Loading...
Need help?
General
