Verathon BladderScan i10 - Component Specifications

70
0900‑5005 REV‑00
7. Verify the position of the printer driver roller in the printer door:
• The printer drive roller’s plastic bushings should rest inside the light gray plastic clips in the printer
door as shown. The gear should be outside the clip.
• If the printer drive roller has fallen out of the gray clips, replace it according to the instructions in the
procedure “Replace the Printer Drive Roller (Optional)” on page72.
8. Load the thermal paper and close the printer door according to the instructions in the procedure “Load
Thermal Paper into the Printer (Optional)” on page56.
9. If the printer continues to produce irregular printouts, contact Verathon CustomerCare.