Verathon GlideScope - PROCEDURE 8. CONFIGURE USER SETTINGS

25
Operations & Maintenance Manual: Setting up
PROCEdURE 8. CONFIGURE USER SETTINGS
You may configure the following settings directly on the unit:
• Date and Time
• Date and Time Format
• Key Click Sound
• Auto Power Off
• Audio Recording
• Auto Recording
• Auto External Video
• Clinic Name
The second page of user settings, as seen in Figure 13, is only available if your GlideScope Video Monitor
is running software version 3.4 or higher. This page of user settings displays system use information, and it
does not contain any configurable settings. If you would like to update the software, see System Software on
page56.
Figure 12. User Settings Screen Page 1
Mode Exit
GlideScope User Settings
Change Date, Time & Settings
01-15-2018 20:35:51 US
UBL Version: 1.4
Core Version: 3.4
Tutorial Version: 1.3
Baton Version:
Key Click Sound: OFF
Audio Recording: ON
Auto External Video: OFF
Clinic Name: CLINIC NAME
Auto Power Off: OFF
Auto Recording: OFF
Next Page
NOTE: PLUG IN POWER ADAPTER TO ENABLE SOFTWARE UPGRADING
UBoot Version: 2.1
Filesystem Version: 3.5
App Version: 3.9
+-
Figure 13. User Settings Screen Page 2
Scope
Power Cycle: 19
Running Time: 0 d 11 h 30 m
Back
GlideScope User Settings
Monitor
Power Cycle: 3
Running Time: 0 d 0 h 30 m
Battery Level: 94%
No USB Drive Detected.
Monitor
Download
Scope
Download
Blade
Power Cycle: 370
1. If a USB flash drive is inserted into the monitor, remove it.
2. Press the Power button. The monitor turns on.
3. Press and hold the Tutorial button , and while continuing to hold it, press the Snapshot button .
The User Settings screen appears on the monitor. The configurable user settings are displayed in yellow,
and the selected setting is highlighted in red.
4. Customize your user settings by using the following buttons:
• Press the Record button to select the parameter you want to set.
• Press the Snapshot button to decrease the parameter value.
• Press the External Video button to increase the parameter value.
• When inputting the Clinic Name, the Tutorial button moves the selection to the next letter. Press
the Record button twice to return the selection back to the Date/Time setting.
• To view the second page of user settings, press the Record button until Next Page is highlighted
in red, and then press the Tutorial button . To exit the second page of user settings, press the
Tutorial button again.
5. When you are finished customizing the settings, press the Record button until the option Exit is
available in the gray bar, and then press the Tutorial button . This saves the parameters, and the User
Setting screen closes.