56
MAINTENANCE & SAFETY
PERIODIC INSPECTIONS
In addition to the user performing routine inspections before and after every use, periodic inspections should
be performed to ensure safe and effective operation. It is recommended that an operator familiar with the
instrument perform a full visual inspection of all components at least every three months. The inspector
should check the system for the following:
• External damage to the equipment
• Damage to the power supply or adapter
• Damage to the connectors or cable insulation
Report any suspected defects to Verathon
®
Customer Care or your local representative. For contact
information, visit verathon.com/support.
GLIDESCOPE VIDEO MONITOR BATTERY
Under normal operating conditions, the monitor battery will last 2–3 years; or approximately 500 charge/
discharge cycles. For more information about the battery, see the Component Specifications section on
page61.
The battery is not user‑replaceable. In case of battery malfunction, do not attempt to replace the monitor
battery. Any attempts to replace the battery by unauthorized service technicians may cause serious harm to
the user and will void the warranty. Please contact your Verathon Customer Care Representative for more
information on battery replacement.
SYSTEM SOFTWARE
Verathon may release software upgrades for the GlideScope Video Monitor. Software upgrades are supplied
directly by Verathon or an authorized representative, and installation instructions are provided with the
upgrade.
This manual documents the most current version of the GlideScope Video Monitor software. If your monitor
does not function as described in this manual, or to determine if your software should be updated, contact
Verathon Customer Care.
Do not perform any software upgrades from third‑party vendors or attempt to modify the existing software.
Doing so may damage the monitor and void the warranty.
To Next Page
Loading...
