Vertical Express LD-16 - Page 38

Existing Cab Header Installation LD-16 Door Operator - Modernization
30 © Vertical Express
Universal MOD Kit
(continued)
5. Install the header support. See Figure 25.
a. Place the strut under the top angle of the header, and cut off the excess.
b. Align the end clip with the strut at the first set of slots on the strike side.
Side opening distance = 3
11
/
16
" – 3
3
/
4
"
c. Use the included hardware to attach the end clips to each end of the strut.
d. Install the rear header support brackets.
Figure 25 - Header Support Installation

Strut
First Set of Slots on Side with Strike
3ƣƣƭƍƒ" – 3 ¾ "
Side-Opening
Clear Opening
End Clip
Rear Header Support
Strut;
ĀûNģ
Excess
Dimensions shown are reference points and apply to TKE or Dover equipment ONLY.