Vertiv | SmartAisle2 | User Manual 103
Installation
Figure 2-114 Mounted temperature and humidity sensors
Sensors mounted 4DI
The magnet is installed for the IRM-S04DIF sensor on the door frame. The process for installation is the same
as that of the Temperature and Humidity sensor. It should be placed in the cabinet housing the RDU-A G2
preferably.
Installation of the water sensor
• Water sensor mounting directions and instructions can be found in the IRM-S01W-belt type water sensor user
manual.
• Vertiv recommends the installation in the bottom of the air conditioning.
• Flooding test strip connector should be pasted to the accompanying cable tie holder along with the detection
lashing belt in a firm and organized manner.
To Next Page
Loading...
