Vertiv | SmartAisle2 | User Manual 104
Installation
Installation of smoke sensors
• Remove the plug buckle skylightroof support The cable that detects smoke from over the line passes through
the hole where the holder is mounted in the frame of the skylight roof.
Figure 2-115 Installation of a smoke bracket
• The smoke detector device is mounted on the smoke face by the base fixing screws. The smoke detector
wiring is then connected to the detector from the hole next to the smoke base.
Figure 2-116 Smoke installation
• Remove the plug buckle for the passage of cable.
• Excess cable line is drawn through the hole to minimize the improved aesthetics of the exposed cable.
To Next Page
Loading...
