Vertiv | SmartAisle2 | User Manual 55
Installation
• Mounting the Safety Auxiliary light
Install the safety light sensor on the right side of the rail. The safety light sensor photoelectric head of the
receiving end and the light-emitting end are installed in the left and right posts below the hole; wire the safety
light sensor and door operator based on the wiring diagram. The cable is bypassed from the top of the motor and
the controller, and is fixed with the hook and loop fastener. Wire the photoelectric head cable and safety light
sensor as shown in Figure 2-50.
Figure 2-50 Auxiliary light installation
Figure 2-51 Safety light sensor wiring routing
• Ensure the wiring is inserted in the end accurately as an incorrect connection can cause malfunction.
• Do not err in the wiring order; else, a wrong connection will result in no action.
• While installing the auxiliary light probe, prevent it from falling, collision, or external shocks as it leads to
malfunction.
To Next Page
Loading...
