Vimar Eikon 20461 - Page 108

50 - ENGLISH
7.4.3
Insert a MASTER smart card, already pro-
grammed by the synchronising reader/
programmer, into the reader being syn-
chronised.
The device waits for the synchronising smart
card for about 2 minutes, after which the LED
turns yellow and no further commands are ac-
cepted.
To resume normal operation, place dip-switch 2
in the OFF position.
7.4.2
Press the front button within 9 seconds.
The LED turns green.
Warning!
If the button is not pressed within 9 seconds, the
LED turns green and the system switches to the
“Initialise reader and program MASTER smart
cards” procedure.
7.4.6
To exit the procedure, place dip-switch 2
in the OFF position.
If dip-switch 2 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 2 in the OFF
position.
7.4.4
The LED switches off to signal that the
smart card code has been copied, and
the reader/programmer synchronised.
7.4.5
Remove the smart card.
The LED turns green again.
Synchronising
card
Synchronising
card
2 minutes
green
green
yellow
1 2 3 4
6
7 8
ON
green
off
off