ENGLISH - 51
7.4.9
Insert into the reader a MASTER smart
card programmed by that same reader,
to enable continuation of the procedure.
7.4.10
The LED turns off to indicate that the
smart card has been recognised.
If the smart card is not recognised the LED turns
red. Remove the incorrect smart card and insert
the correct one.
7.4.11
Remove the smart card which has been
recognised.
The LED turns green again.
Synchronising an already-initialised reader
7.4.8
Press the front button within 9 seconds.
The LED turns green.
Warning!
If the button is not pressed within 9 seconds, the
LED turns green and the system prepares for the
“Initialise reader and program MASTER smart
cards” procedure.
To exit the procedure, place dip-switch 2 in the
OFF position.
Repeat the procedure from step 7.4.7.
7.4.7
Place dip-switch 2 on the reader being
synchronised in the ON position.
The LED lights up yellow.
1 2 3 4
ON
yellow
green
Card
already
programmed
Card
already
programmed
green
off
green
To Next Page
Loading...