Vimar Eikon 20461 - Page 110

52 - ENGLISH
7.4.12
Insert a MASTER smart card, already pro-
grammed by the synchronising reader/
programmer, into the reader being syn-
chronised.
7.4.13
The LED switches off to signal that the
MASTER smart card code has been cop-
ied, and the reader/programmer synchro-
nised.
If no synchronising MASTER smart card is insert-
ed within 2 minutes, the LED turns yellow and
no further commands are accepted. In this case
it is necessary to place dip-switch 2 in the OFF
position to exit the procedure.
7.4.15
To exit the procedure, place dip-switch 2
in the OFF position.
If dip-switch 2 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 2 in the OFF
position.
7.4.14
Remove the smart card.
The LED turns green again.
Synchronising
card
Synchronising
card
2 minutes
green
yellow
off
1 2 3 4
6
7 8
ON
green
off