Vimar Eikon 20461 - Page 113

ENGLISH - 55
To program SLAVE smart cards for use with the reader in
electronic switch mode, see:
7.2 Initialising the reader and programming
SLAVE smart cards
(pg. 44)
To change the code of the reader in electronic power
switch mode and that of the SLAVE smart cards, see:
7.3 Changing the codes of the reader and
SLAVE smart cards
(pg. 47)
To synchronise the reader in electronic switch mode with
MASTER smart cards, see:
7.4 Synchronising readers with MASTER
smart cards
(pg. 49)
If no smart cards are inserted for about 2 min-
utes, the LED turns yellow and no further com-
mands are accepted.
To resume normal operation, place dip-switch 2
in the OFF position.
8.1.7
Remove the smart card.
The LED turns green again, waiting for
other MASTER smart cards to program.
To program additional MASTER smart
cards, repeat the procedure from
step8.1.5.
8.1.8
To exit the procedure, place dip-switch 2
in the OFF position.
MASTER
card
MASTER
card
2 minutes
1 2 3 4
6
7 8
ON
green
yellow
off