ENGLISH - 17
5.5.4
The LED switches off to signal that the
smart card code has been copied, and
the reader/programmer synchronised.
5.5.3
Insert a smart card already programmed
by the synchronising reader/programmer,
into the reader being synchronised.
5.5.2
Press the front button within 9 seconds.
The LED turns green.
Warning!
If the button is not pressed within 9 seconds, the
LED lights up green and the system switches to
the “Initialise reader and program smart cards”
procedure.
To exit the procedure, place dip-switch 1 in the
OFF position.
Repeat the procedure from step 5.5.1.
5.5.5
Remove the smart card.
The LED turns green.
The device waits for a synchronising smart card
for about 2 minutes, after which the LED turns
yellow and no further commands are accepted.
To resume normal operation, place dip-switch 1
in the OFF position.
Synchronising
card
Synchronising
card
green
green
2 minutes
off
green
yellow
To Next Page
Loading...