18 - ENGLISH
5.5.6
To exit the procedure, place dip-switch 1
in the OFF position
If dip-switch 1 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 1 in the OFF
position.
5.5.7
Place dip-switch 1 on the reader being
synchronised in the ON position.
The LED lights up yellow.
5.5.9
Insert into the reader a smart card pro-
grammed by that same reader, to enable
continuation of the procedure.
The device waits for a programmed smart card
for about 2 minutes, after which the LED turns
yellow and no further commands are accepted.
To resume normal operation, place dip-switch 1
in the OFF position.
5.5.8
Press the front button within 9 seconds.
The LED turns green.
Warning!
If the button is not pressed within 9 seconds,
the LED turns green and the system switches to
the “Change the reader and smart card codes”
procedure.
To exit the procedure, place dip-switch 1 in the
OFF position.
Repeat the procedure from step 5.5.7.
Synchronising an already-initialised reader
1 2 3
ON
1 2 3
ON
off
yellow
Card
already
programmed
Card
already
programmed
green
green
To Next Page
Loading...