ENGLISH - 19
5.5.14
Remove the smart card.
The LED turns green again.
5.5.12
Insert a smart card programmed by the
synchronising reader.
If no synchronising smart card is inserted within
2 minutes, the LED turns yellow and no further
commands are accepted. In this case it is neces-
sary to place the dip-switch 1 in the OFF position
to exit the procedure.
5.5.10
When the green LED turns off, the smart
card has been recognised.
If the smart card is not recognised, the LED turns
red and remains illuminated until the card is re-
moved.
5.5.11
Remove the recognised smart card.
The LED turns green again.
5.5.15
To exit the procedure, place dip-switch 1
in the OFF position
If dip-switch 1 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 1 in the OFF
position.
5.5.13
The LED switches off to signal that the
smart card code has been copied, and
the reader/programmer synchronised.
1 2 3
ON
off
green
off
Synchronising
card
Synchronising
card
off
green
green
To Next Page
Loading...