Vimar Eikon 20461 - Page 99

ENGLISH - 41
6.8.18
To exit the procedure, place dip-switch 1
in the OFF position.
If dip-switch 1 is not placed in the OFF position
within 2 minutes, the LED turns yellow and no
further commands are accepted. To resume
normal operation, place dip-switch 1 in the OFF
position.
6.8.15
Insert a SLAVE smart card, already pro-
grammed by the synchronising reader/
programmer, into the reader being syn-
chronised.
The device will await the synchronising smart
card for about 2 minutes, after which the LED
turns yellow and no further commands are ac-
cepted.
To resume normal operation, place dip-switch 1
in the OFF position.
6.8.17
Remove the smart card.
The LED turns green again.
6.8.16
The LED switches off to signal that the
smart card code has been copied, and
the reader/programmer synchronised.
6.8.14
Remove the MASTER smart card.
The LED turns green again, waiting for a
synchronising SLAVE smart card.
Synchronising
card
Synchronising
card
MASTER
card
MASTER
card
green
green
1 2 3
4 5 6
7 8
ON
off
green
off