n Name: Here "DP" is shown. If you change the name, the new
name appears in the Siemens SIMA
TIC Manager.
n Interface: The PROFIBUS address is shown here.
n Properties: With this button the properties of the PROFIBUS DP
interface may be preset.
n Comment: You can enter the purpose of the PROFIBUS interface.
n Diagnostics: A diagnostics address for PROFIBUS DP is to be
preset here. In the case of an error the CPU is informed via this
address.
n Operating mode: Here the operating mode of the PROFIBUS part
may be preset. More may be found at chapter "Deployment
PROFIBUS Communication".
n Configuration: Within the operating mode "DP-Slave" you may
configure your slave system. More may be found at chapter
"Deployment PROFIBUS communication".
n Clock: These parameters are not supported.
5.8.4 Parameters for MPI/DP
The properties dialog of the MPI interface is opened via a double click
to the sub module MPI/DP
.
n Short description: Here the short description "MPI/DP" for the MPI
interface is specified.
n Order no.: Nothing is shown here.
n Name: At Name "MPI/DP" for the MPI interface is shown. If you
change the name, the new name appears in the Siemens
SIMA
TIC Manager.
n Type: Please regard only the type "MPI" is supported by the VIPA
CPU.
n Interface: Here the MPI address is shown.
n Properties: With this button the properties of the MPI interface
may be preset.
n Comment: You can enter the purpose of the MPI interface.
n Diagnostics: A diagnostics address for the MPI interface is to be
preset here. In the case of an error the CPU is informed via this
address.
n Operating mode, Configuration, Clock: These parameters are not
supported.
Address
General
Address
VIPA System 300SDeployment CPU 314-6CF03
Setting standard CPU parameters > Parameters for MPI/DP
HB140 | CPU | 314-6CF03 | GB | 16-43 68
To Next Page
Loading...