5.11 Access to the internal Web page
The Ethernet PG/OP channel provides a web page that you may
access via an Internet browser by its IP address. The web page con-
tains information about firmware versions, current cycle times etc.
The current content of the web page is stored on MMC by means of
the MMC-Cmd WEBP
AGE.
Ä
Chapter 5.19 ‘CMD - auto commands’
on page 92
A PG/OP channel connection should be established between PC with
Internet browser and CPU 314-6CF03. This may be tested by Ping to
the IP address of the PG/OP channel.
The access takes place via the IP address of the Ethernet PG/OP
channel. The web page only serves for information output. The moni-
tored values are not alterable.
CPU with Ethernet-PG/OP
Slot 100
VIPA 314-6CF03 V.... Px000164.pkg,
SERIALNUMBER 05439
Order no., firmware vers.,
package, serial no.
SUPPORTDATA :
PRODUCT V3420, HARDW
ARE V0114, 5679H-V20 ,
HX000027.110 , Bx000227 V6420, Ax000086 V1200,
Ax000056 V0220, fx000007.wld V1140, FlashFileSystem :
V102
Information for support
Memorysizes(Bytes):LoadMem:LoadMem : 2113536,
W
orkMemCode : 1048576, WorkMemData : 1048576
Information about memory con-
figuration, load memory, work
memory (code/data)
OnBoardEthernet : MacAddress : 0020D50144C1, IP-
Address : 172.20.120.62, SubnetMask : 255.255.255.0,
Gateway : 172.20.120.62
Ethernet PG/OP: Addresses
Cpu state : Run CPU state
FunctionRS485 X2/COM1: MPI
FunctionRS485 X3/COM2: DPM-async
Operating mode RS485
n MPI: MPI operation
n DPM: DP master operation
or
PtP: point to point operation
Access to the web page
Requirements
Web page
VIPA System 300SDeployment CPU 314-6CF03
Access to the internal Web page
HB140 | CPU | 314-6CF03 | GB | 16-43 78
To Next Page
Loading...