Calibration
Locking and Unlocking Calibration
VT400 Technical Manual, Rev. A5 37 Doc # UM-VT400-EN
4.4.1 Sealing Indicator Enclosure with Stickers
After calibration, you can seal the indicator with two stickers:
A non-removable label, to prevent unauthorized opening of the indicator
enclosure (Figure 5)
A lead wire seal or hard plastic sticker, to prevent unauthorized tampering with
the load cell connector (Figure 6)
Figure 5 – Non-removable sticker
Figure 6 – Lead wire seal / hard plastic sticker
To Next Page
Loading...
