Troubleshooting
Checking Load Cell Connection
VT400 Technical Manual, Rev. A5 61 Doc # UM-VT400-EN
Error code Possible cause Actions to be taken
Err 26 Printer has no paper.
Add paper to the printer, and press PRINT
(
) to retry. If you can’t add paper, and
you would like to use the indicator
anyway, press ZERO (
).
Err 30 The host PC is not connected, or the
communication link failed.
Make sure the computer is connected, and
press PRINT (
) to retry. If there is some
problem with the computer, but you would
like to use the indicator anyway, press
ZERO (
).
Err 33 The host PC did not return a proper
response (an acknowledgement required
by the communication protocol).
Make sure the computer is connected, and
press PRINT (
) to retry. If there is some
problem with the computer, but you would
like to continue using the indicator
anyway, press ZERO (
).
Err 55 Alibi memory is full. The memory serial
number resets to 0000. From now on,
each new memory entry overwrites the
oldest record in alibi memory.
Press ZERO (
).
Err 56 Printing error. Tare is currently active, but
selected print format does not support net
weight.
Printout aborted. Printing stops and
returns to weighing mode.
Err 57 The weight measurement could not be
saved to alibi memory.
Press ZERO (
).
Err 67 The area of memory that stores the
accumulated total weight is corrupted.
Print/reset the total weight
Err 69 The area of memory that stores the
accumulated total weight has overflowed.
In other words, the total weight is too
large.
Print/reset the total weight
9.2 Checking Load Cell Connection
If there appears to be a problem with the load cell connection:
Check input and output resistance.
Check resistance between any terminal and shield.
Check load cell connection and cable.
To Next Page
Loading...
