VOLTA FBW II Series User Manual

Position both sides of the belt on the Pliers with the belts’
patten facing up. Position the Adapters onto the Belt.
Align the belt patten to the Adapter grooves.
To ensure correct position on the pliers and right pitch of
thepattern, place the adapter on the belt and cut the two
ends of the belt along the “Cutting” side of the Adapter.
Position and then tighten the FBW Crossbars. Weld the
belt according to the FBW Instructions Manual.
Trim and check the weld. A good weld will be free of cracks
and defects.
4.2. Welding MiniCleat (MC)
You must be familiar with the instructions for welding with FBW before continuing
with this procedure.
Required Tools:
FBW Welding Kit
MC Adapter Set for FBW - 301 Cat. #813072510
MC Adapter Set for FBW - 721 Cat. #81307241
MC Adapter Set for FBW - 1061 Cat. #81310601
MC Adapter Set for FBW - 1301* Cat. #81313008
V Trim Knife Cat. #8153108
Utility Knife
1 2
4
3
* Non-standard
** Positioner for welder FBW - 1301 and FBW - 1701 only.
Instructions on Page 22.
Positioner for welder** Cat.#81626342
14
Volta Belting Technology Ltd.
Welding & Fabrication Tools FBW-Flat Butt Welding System Model II

VOLTA FBW II Series Specifications

General

Brand	VOLTA
Model	FBW II Series
Category	Welding System
Language	English