2.2. The Storage Case
2.3. The Electrical System
Electrical Shock Hazard - Never remove the ground from the power cord or
internal wiring.
2.4. Care and Maintenance
The storage case is meant to protect the tools against dirt and damage during transportation. The case is designed to
store the entire FBW system. Tools and other items that do not belong to the FBW Welding System should not be
placed in the storage case. Loose, unsecured items may move around and damage the Teflon coating of the Welder.
Do not store chemicals in the FBW storage case - chemical fumes and possible spills may damage the wiring and
internal components
of the Controller.
All metal parts of the FBW Welding System are grounded. Ensure that the electrical plug is connected to a power
source with an earth ground and a Residual-current device (RCD). The thermo-couple wires must not be disconnected
as this will cause uncontrolled heating and damage the Welder.
Keep the system dry and clean.
Occasionally apply a light coating of oil to sliding metal parts.
The quality of the finished weld is affected by the condition of the Welder. To obtain the highest quality results from your
Welder, always wipe the Welder’s flat surfaces with a clean cotton cloth to remove material and dirt immediately after welding.
When welding is completed, return the tools to their storage box. There is no need to wait for the Welder to fully cool
down. The partitions inside the box will ensure that the system does not move during transportation and guarantee the
tool’s long lasting functioning.
The Welder must be cleaned while hot. Because the temperature of the welder
is high, extra care must be taken to avoid burns. It is recommended that you
wear protective gloves.
7
www.voltabelting.com
To Next Page
Loading...
Need help?
General
