EasyManuals Logo

VOLTA FBW II Series User Manual

VOLTA FBW II Series
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
12. Calibrating the FBW/PDW Welder Control box & Welder Bar
These instructions apply to Temperature Controller Model
SHINKO-BCS2S00-10
Before calibrating the welder, make sure it is not plugged to a power source and that the
Welder Bar is at room temperature.
Connect the Welder-Bar to the controller and secure the latch on the connector.
Place the Welder Bar up-right on an even surface where it is safe for it to heat up.
DO NOT Touch the Welder Bar as it heats up. Use protective gloves and use the bar
handle to hold the Welder Bar.
1. Temperature Scale Selection
Select Fahrenheit or Celsius temperature scales.
a. Plug the control box to an appropriate outlet and Turn the Main Power switch on to ‘I’ and wait until the measured
temperature is displayed on the PV line & the SV line displays the temperature set value. This state is referred to from here
on as the "Normal Display".
b. Press and hold & then for 3 seconds until appears in the PV line.
On the SV line the selected Thermocouple Type and temperature scale are shown.
c. Use the or to scroll through the thermocouple & scale options. There are about 20 options to scroll through.
CHOOSE:
either thermocouple
= Centigrade (°C) scale.
or thermocouple
= Fahrenheit (°F) scale.
d. To save your selection long press on the key until the display returns to Normal display.
2. Temperature Limit Setting
Sets the Welder’s maximum allowable temperature.
Select the Welder limits temperature.
a. Press and holdd & then keys until appears in the PV line.
b. Press the button. The symbol will appear in the PV line.
The value on the SV line is the maximal allowable set temperature value.
c. Press on or to set the maximum allowable temperature (250°C / 482°F).
d. Press the button once. The symbol will appear in the PV line.
The value on the SV line is the minimal allowable set temperature value.
NOTE: There could be a minus (-) sign to the left of the value.
e. Use the or keys to set the minimum allowable temperatures are between
0°C / 0°F – (factory settings) to 200°C / 390°F.
Setting higher minimum may prevent error in setting the desired working temperature.
f. To save your selection press & hold on until the display changes back to Normal display.
g. Press and hold both & for 3 seconds until appears in PV line.
h. Press several times until the symbol appears in the PV line.
i. Use the or keys to set the value to (1.0).
j. To save your selection press & hold on until the display changes back to Normal display.
3. Welder Working Temperature
Set the Welder operating temperature.
a. Press until the symbol appears on the PV line.
b. Press on or to set the desired temperature (220°C / 428°F).
c. Press on key once to save and return to the Normal display.
Turn the Main Power switch off to “O”.
35
www.voltabelting.com

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VOLTA FBW II Series and is the answer not in the manual?

VOLTA FBW II Series Specifications

General IconGeneral
BrandVOLTA
ModelFBW II Series
CategoryWelding System
LanguageEnglish

Related product manuals