Table of Contents
Page
How to use this manual
3
Symbols used in this manual
3
3
1. Introduction
4
2. Technical Specifications
5
3. Welding Instruction
4.
Welding Texture Top Belts
9. General Tips
10. Troubleshooting Guide
11. FBW System Model II Shinko Controller and Welder Electrical Diagram
12. Calibrating the FBW Welder System Model II Shinko Controller
13. Pitch Gauge Measuring Tool for the Positive Drive Belts
5. Instructions for Splicing Reinforced Flat Belts
6. Instructions for Welding Narrow Belts
7. Instructions for Welding H Material Belts
8. Welding Positive Drive Belts
9
17
2.1. FBW (Flat Butt Welding System Model II) Layout
2.2. The Storage Case
2.3. The Electrical System
2.4. Care and Maintenance
2.5. Safety Precautions
2.6. Warning Notice for Welding Tools
6
3.1. Preparing the Temperature Controller
3.2. Preparing the Pliers
3.3. Preparing the Belt
3.4. Welding the Belt
3.5. Trimming and Checking the Weld
4.1.
Saw Tooth (IST) & Nub Top (NT)
4.2.
MiniCleat (MC)
4.3.
Spikes (SP)
4.4. Cresent top (CT)
37
33
34
35
33
7
7
7
8
8
9
9
10
11
14
15
20
22
23
22
18
19
19
20
25
27
29
31
13
13
12
8.1. Instructions for Welding SuperDrive™ H/M Material Belts
8.2. Instructions for Welding SuperDrive™ Belts Using FBW Adapter
8.3. Positioner for Welder
8.4. Welding DualDrive
TM
Belts
8.5. Welding Mini SuperDrive™ and Mini DualDrive™ Belts
8.6. Welding Mini SuperDrive™ MiniCleat Belt
8.7. Welding DualDrive™ SP (DDSP) Belts and DDSP Lace
8.8. Welding Volta Hinge Lace