2.5. Safety Precautions
2.6. Warning Notice for Welding Tools
Volta Belting accepts no liability for use of this tool in a manner other than that specified in this manual.
Volta Belting accepts no responsibility for unauthorized modifications performed on this tool.
This Instruction Manual and the warnings contained herein must be read carefully and kept clearly visible
in the vicinity of the FBW Welding Tool.
Failure to pay attention to these warnings can lead to accidents, injuries or damage to health.
1. Always use the original storage box to keep the welding tool when not in use. Always store tools in a
dry and secure environment.
2. Select and use the most appropriate welding tool for your application. The selection is based on
material dimensions.
3. Use the welding tool only at its rated voltage (See Table 1 - FBW Welder System Specifications).
4. Ensure that the unit is connected to an earth grounded power source. Failure to comply with this
requirement can cause electrical shock.
5. Do not use the welding tool in a damp or wet environment.
6. Do not carry the welder by its power cord or use it for unsuitable purposes.
7. Protect the cord from heat and sharp objects.
8. Do not pull on the power cord to remove the plug from its socket.
9. Always work in a well ventilated area when welding. Some materials can generate toxic fumes when
overheated.
10. Always weld on a non-combustible surface and be aware of surrounding materials. Heat may cause
fire or damage other materials.
11. Ensure that the surface of the welding bar is clean and in good condition.
12. Hold the Welder by the handles only. The Welder surface can be very hot and will cause burns.
13. If the unit requires repair, return it to Volta Belting or to your local Volta distributor.
8
Volta Belting Technology Ltd.
Welding & Fabrication Tools FBW-Flat Butt Welding System Model II
To Next Page
Loading...
Need help?
General
