VOLTA FBW II Series User Manual

21
22
Position the Adapters onto the Pliers with the “Cutting”
sides facing outwards. Position both sides of the belt on
the Pliers. The belts’ teeth should face down and
interlock with the grooves of the adapters.
Position the FBW Welder in place. Apply consistent and
gentle pressure until the Stoppers do not allow you to
continue. Immediately open the Pliers. Weld the belt
according to the welding instructions in the FBW Manual.
Trim and check the weld. A good weld will be free of
cracks and defect. Pitch tolerance should be +0 mm,
-1mm.
Position the crossbar without tightening the knobs. Close
the plier and push the two ends together, this will align the
two ends of the belt with the adaptors. Now tighten the
FBW Crossbars.
5
6
7
8
24
Volta Belting Technology Ltd.
Welding & Fabrication Tools FBW-Flat Butt Welding System Model II

VOLTA FBW II Series Specifications

General

Brand	VOLTA
Model	FBW II Series
Category	Welding System
Language	English