18
VOX Lil' Looper Owner's manual
Using the metronome as a guide while you record
You can use the metronome as a guide while you
record a loop. Adjust the following seings before
you start recording.
1. PresstheTAPbuonseveraltimestospecifythe
tempo.
The metronome will sound at the tempo you specied.
The METRONOME buon will light up red.
The TAP buon will blink at the tempo you
specied.
2.
Toadjustthevolumeofthemetronome,hold
downtheMETRONOMEbuonandturnthe
LOOPLEVEL/VALUEknob.
3.
Tospecifythetimesignature,holddowntheTAP
buonandturntheLOOPLEVEL/VALUEknob.
The time signature is set to 4/4 when the power is
turned on.
The range of time signatures is 1/4 , 3/4, 4/4, 5/4, and 7/4.
You can’t change the denominator of the time signature.
You can’t change the time signature or tempo aer
recording.
About the metronome operation
The functionality of the metronome may vary
depending on the record/playback mode. ()p. 21 “The
recording/playback function of the Lil’ Looper”)
Whentherecord/playbackfunctionisinSyncmode
The metronome will run in sync with the loop when
recording and the metronome are on. Even if a loop is
stopped, the metronome will continue to run internally
in sync with the loop. As a result, the metronome will
synchronize with the loop the next time playback is
initiated. If the loop is deleted, the synchronization
will be canceled.
Whentherecord/playbackfunctionisinIndividual
mode
In Individual mode, the metronome will stop if the
loop is stopped. If a loop starts to record or playback,
the metronome will run from the rst beat.