Operation
6.13 Range Limits
44
Operator’s Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
6.13 Range Limits
The transmitter signal will remain in contact with the machine at distances up
to 20 m (65 ft). If operating into direct sunlight or with a low battery charge,
the operating range may decrease.
If the machine moves out of range, the amber lights on the machine will stop
blinking and come on continuously. The machine will immediately stop mov-
ing, and vibration will stop. The operator must then move closer to the ma-
chine to reestablish contact. If contact is not made within 30 seconds, the
engine will shut off.
wc_gr012186
20m (65 ft.)
20m (65 ft.)
2 m (6.6 ft.)
2 m (6.6 ft.)
OK
Fig.15: Range limits
6.14 Operating Characteristics
WARNING
Crushing hazard or machine damage
The roller's sensing system will not stop the roller from moving when the
transmitter is in the storage compartment or on the side of the roller.
► When operating from the side of the machine, always maintain a dis-
tance of at least 2m (6.6 ft) from the machine.
► Never operate the machine with the transmitter in the storage compart-
ment.
To Next Page
Loading...
Need help?
General
