Operation
6.17 Machine Stability
46
Operator’s Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
• Fuel lines
• Fuel level
• Condition of oil cooler and radiator cooling fins
• Water level in tank
• Air cleaner
Additional daily tasks
• Check for loose or missing fasteners. Replace as needed.
• Make sure scraper bars are clean and properly adjusted.
• Clean the transmitter and receiving eyes.
• Check that receiving eyes blink rapidly when approached by the opera-
tor.
• Check that the articulated joint locking bar is in the storage position.
• Check that the SmartControl
TM
transmitter module and the machine’s de-
coder module are set to the same control channel.
Before operating
• Check the machine for fluid leaks. Repair them before operating.
• Unlock the articulated steering joint.
• Adjust the drum scraper position.
• Check the work area for obstructions. Remove all obstructions.
• Check that all handles, steps, and platforms are free of dirt, snow,
grease, fuel, or anything else which might endanger operator safety.
• Allow the engine to warm up according to the following schedule:
Ambient temperature Time (minutes)
Above 0°C (32°F) 5
Below 0°C (32°F) 15
1)
1) More time may be required if hydraulic controls are sluggish.
6.17 Machine Stability
WARNING
Crushing hazard
Certain job site conditions or operating practices may adversely affect ma-
chine stability.
► Follow the instructions below to reduce the risk of tipping or falling inci-
dents.
Surface conditions
Pay attention to changing surface conditions while operating the machine.
Adjust speed and travel direction as necessary to maintain safe operation.
To Next Page
Loading...
