Shutdown
10.1 Machine Disposal and Decommissioning
82
Operator’s Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
10 Shutdown
10.1 Machine Disposal and Decommissioning
Introduction
This machine must be properly decommissioned at the end of its service life.
Responsible disposal of recyclable components, such as plastic and metal,
ensures that these materials can be reused which conserves landfill space
and valuable natural resources.
Responsible disposal prevents toxic chemicals and materials from harming
the environment. This machine contains several components that may be
considered hazardous waste in many areas:
• Operating fluids, including fuel, engine oil, grease, and hydraulic oil
• Batteries
• Electronic components, such as circuit boards, control panels, LEDs,
and joysticks
Before decommissioning this machine, read and follow local safety and envi-
ronmental regulations pertaining to the disposal of construction equipment.
Preparation
• Move the machine to a protected location where it will not pose any
safety hazards and cannot be accessed by unauthorized individuals.
• Ensure that the machine cannot be operated from the time of final shut-
down to disposal.
• Drain all fluids, including fuel, engine oil, and coolant.
• Seal any fluid leaks.
• Remove the battery.
Disposal
• Disassemble the machine and separate all parts by material type.
• Dispose of recyclable parts as specified by local regulations.
• Dispose of all non-hazardous components that cannot be recycled.
• Dispose of waste fuel, oil, and grease in accordance with local environ-
mental protection regulations.
To Next Page
Loading...
Need help?
General
