Operation
6.24 Replacing the Battery Pack
54
Operator’s Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
6.24 Replacing the Battery Pack
Fig.21: Transmitter battery pack
The battery pack (1) on the back of the transmitter should be replaced once
a year or when it no longer holds a full charge.
To replace the battery pack, press the orange tab (2) and slide the battery
pack out.
Notes
• A new battery may not be fully charged. After replacing the battery,
charge it for approximately one hour to ensure it is at full capacity.
• In the interests of environmental protection, dispose of used batteries
properly. Do not dispose in trash, or incinerate.
6.25 Charging the Transmitter Battery
Background
The NiMH battery pack in the transmitter has enough capacity to provide
16hours of continuous operation. To maintain battery capacity, recharge it
during nonworking hours by using the onboard docking port.
Note: There is no need to run the NiMH battery completely down before
recharging. The battery can be recharged from any state of discharge with
no loss in performance or life.
Procedure
To charge the battery, perform one of the following procedures:
• Plug the transmitter receptacle(1) into the charging port(2). Slide the
transmitter forward until the battery charge light comes on.
• Plug one end of the control cable into the transmitter receptacle and the
other end into the port(3) on the back of the machine.
Notes
To Next Page
Loading...
Need help?
General
