Operation
6.18 Operating on Slopes
48
Operator’s Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
6.18 Operating on Slopes
WARNING
Crushing hazard
Do not operate the machine sideways on slopes. The machine may tip or roll
over even on stable ground.
► Operate the machine straight up and down on slopes.
Overview
When operating on slopes or hills, special care must be taken to reduce the
risk of personal injury or damage to the machine.
Procedure
• Operate the machine up and down slopes rather than from side to side.
• The machine is equipped with safety switches which will shut down the
engine should the side-to-side operating angle exceed45°. Forward/
backward tilt is not limited by the safety switches.
• For safe operation and for protection of the engine, continuous duty use
should be restricted to slopes of14° (25%grade) or less.
Fig.17: Operating on slopes
6.19 Rollovers
NOTICE
After a rollover, engine damage may occur if it is not serviced appropriately
before being started.
► Do NOT start the machine after a rollover.
► Service the engine to remove any oil that may have been trapped in the
combustion chambers.
► Contact your local dealer for instructions or servicing.
To Next Page
Loading...
Need help?
General
