Wacker Neuson RTLx-SC3 - Maintenance; Periodic Maintenance Schedule; Checking the Hydraulic Oil Level

Maintenance
Periodic Maintenance Schedule 7.1
65
[en-US] | 09/2022 | 5100061327 | RTLx-SC3 | Operator’s Manual
7 Maintenance
7.1 Periodic Maintenance Schedule
Maintenance cycle Personnel For further information
Daily Operating personnel
[}65]
Checking the Hydraulic Oil Level
[}69]
Checking for Loose or Missing Fasteners
[}69]
Checking the Receiving Eyes
[}70]
Cleaning SmartControl™ Transmitter
100 hours Operating personnel
[}66]
Maintaining the Battery
[}69]
Lubricating the Articulated Joint and Steering
Cylinders
[}71]
Draining the Fuel and Water Separator
300 hours Operating personnel
[}71]
Inspecting the Shock Mounts
1000 hours Service personnel
[}67]
Changing the Hydraulic Oil and Filter
As needed Operating personnel
[}66]
Maintaining the Battery
[}70]
Adjusting the Scraper Bars
[}72]
Priming the Fuel System
Maintenance personnel
[}82]
Machine Disposal and Decommissioning
7.2 Checking the Hydraulic Oil Level
NOTICE
Low levels of hydraulic oil may cause damage to hydraulic components.
► If hydraulic oil continually needs to be added, inspect the hoses and
connections for possible leaks. Repair any leaks immediately.
► Do not attempt to remove the vent cover from the hydraulic reservoir.
When
Daily
Requirements
Location
A hydraulic oil level sight glass (1) is located on the side of the hydraulic fluid
reservoir inside the rear section of the machine.
7