Wacker Neuson RTLx-SC3 - Page 64

Operation
6.27 Changing Drums
64
Operator’s Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
M16x25
wc_gr010671
M16x80
5
4
Fig.36: Install the screws
5. Install the three M16x25 screws(4) to the drum in the locations
shown. Use Loctite243 or equivalent on the screws and torque them to
210Nm (155ft.lbs.).
wc_gr010672
712
Fig.37: Narrow scraper
6. Install the narrow scraper(7) using the three screws and washers from
step1. Use Loctite243 or equivalent on the screws and torque them to
86Nm (63ft.lbs.).
7. Repeat the procedure for each drum.