WAGNER EPG S2 Translation Of The Original Operating Manual

11
EPG S2
OPERATING MANUAL
VERSION 09/2017 ORDER NUMBER DOC2317574
4.2.1 SAFE HANDLING OF WAGNER POWDER SPRAY DEVICES
4.2.2 GROUNDING THE DEVICE
4.2.3 PRODUCT HOSES
4.2 SAFETY INSTRUCTIONS FOR STAFF
Use only an original WAGNER powder hose.
Always follow the information in this manual, particularly the general safety instructions
and the warning instructions.
Always follow local regulations concerning occupational safety and accident prevention.
Under no circumstances may anyone  tted with active implants (e.g., a pacemaker)
enter the area where the high-voltage  eld between the spray gun and the work piece
to be coated builds up!
Do not point spray guns at people.
Before all work on the device, in the event of work interruptions and functional faults:
– Switch o the energy/compressed air supply.
– Secure the spray gun against actuation.
– Relieve pressure on spray gun and device.
– In case of functional faults: Identify and correct the problem, proceed as described in
the "Fault Recti cation" chapter.
The electrostatic charge may, in certain cases, give rise to electrostatic charges on the
device. This may result in the formation of sparks or  ames when discharging.
Ensure that the device is grounded before each coating process.
Ground the work pieces to be coated.
Ensure that all persons inside the working area are grounded, e.g., by wearing electrostatically
conductive shoes.
The functionality of grounding cables must be checked regularly (see EN 60204).

WAGNER EPG S2 Specifications

General

Brand	WAGNER
Model	EPG S2
Category	Industrial Equipment
Language	English