WAGNER EPG S2 Translation Of The Original Operating Manual

8
EPG S2
OPERATING MANUAL
VERSION 09/2017 ORDER NUMBER DOC2317574
2.5 REASONABLY FORESEEABLE MISUSE
– Coating work pieces which are not grounded
– Use of defective components and accessories
– Use with non-authorized power spray guns
2.4 SAFETY PARAMETERS
The control unit is only suited for controlling powder spray guns.
Wagner International AG prohibits any other use!
The use of the control unit is only permissible under the following conditions:
– the operating sta have previously been trained on the basis of this operating manual,
– the safety regulations listed in this operating manual are observed,
– the operating, maintenance and repair information in this operating manual is observed,
– and the statutory requirements and accident prevention regulations standards in the
country of use are observed.
The control unit may only be used if all parameters are set and all measurements/safety
checks are carried out correctly.
2.6 RESIDUAL RISKS
Residual risks are risks which cannot be ruled out even in the event of correct use.
If necessary, warning and prohibition signs at the relevant points of risk indicate residual
risks.
Residual risk Source Consequences Speci c measures Lifecycle
phase
Skin contact with
powder lacquers
and cleaning
agents
Handling powder
lacquers and
cleaning agents
Skin irritation, allergies Wear protective
clothing
Operation,
observe safety data
sheets
maintenance,
disassembly
Powder lacquer
in air outside the
de ned working
area
Lacquering outside
the de ned
working area
Inhalation of substances
which are hazardous to
health
Observe work and
operation instructions
Operation,
maintenance

WAGNER EPG S2 Specifications

General

Brand	WAGNER
Model	EPG S2
Category	Industrial Equipment
Language	English