Support Email/ Skype: service2@wansview.com 7
camera's sensors.
Ensure that the camera is in a well ventilated area to prevent overheating.
6. Operation and Maintenance
Do not touch the camera sensor or lens directly.
To clean dust or dirt off of the lens, use an air blower or a microfiber cloth.
7. Accessories
Be sure to use only the accessories recommended by the manufacturer.
Before installation, please open the package and check to ensure that all of the components are present.
Contact the retailer where you purchased from the camera, or Wansview directly, if anything is broken or missing in the package.
To Next Page
Loading...
