2011980_d•en•2015-12-01
We reserve the right to make technical changes
26
WAREMA climatronic® WebControl
terminating resistance120Ω
Fig. 25 Reset button for loading the firmware
The status LED briefly lights up orange and then alternates between flashing
red and green.
Both LEDs remain completely off for a short period.
The status LED shines red until the website is loaded.
The status LED and controlbus LED alternatingly flash green (back and
forth). The status LED thus indicates that no project is available yet, and the
controlbus LED thereby indicates that communication is normal.
The status LED shines steady green once the update has been successfully
completed.
The previously saved project file has been loaded into the WAREMA clima-
tronic WebControl from the SD card.
NOTE If the status LED flashes green, the project was not previously saved on the
SD card and was deleted from the WAREMA climatronic WebControl.
The factory settings of the device have been restored.
7.2 Resetting the device to
the factory settings
Press and hold the Mode button (= resetting the device to factory settings).
The status LED slowly flashes red.
After approx. 10s, the status LED rapidly flashes red.
You can then release the push button, and the device will be reset to the fac-
tory settings.
NOTE When you reset the device to the factory settings, all data is deleted.
System
To Next Page
Loading...
Need help?
General
