2011980_d•en•2015-12-01 We reserve the right to make technical changes
13
4 Commissioning
Before you commission the WAREMA climatronic WebControl, you will need
to have an existing project on your WAREMA climatronic system. Follow the
instructions provided here to complete the commissioning process. Use the
Wizard, which guides you through the menu, or the comfortable WAREMA
climatronic studio software.
4.1 USB / RS 485
port
There are two types of ports on your WAREMA climatronic control panel: in
the WAREMA climatronic menu illustrated below, you can choose to enable
the USB port on the left side of the control panel or, alternatively, the RS 485
port on the back of the panel:
Fig. 10 WAREMA climatronic menu for selecting the correct port type
To enable use of the WAREMA climatronic WebControl, the RS485 port on
the back of the WAREMA climatronic control panel must be selected.
(The USB port is required for connecting a PC with the WAREMA climatronic
studio and is not needed in this case).
4.2 Access through a
browser
You can commission the WAREMA climatronic WebControl using your
browser or the free app (see Chapter 10 on page 29).
The following description illustrates how to commission the WebControl from
a laptop using a browser.
Once you have connected the WAREMA climatronic WebControl, open your
browser.
If you are using a PC operating system, type "http://webcontrol-c" in your
browser's address bar.
If you are using a MAC operating system, type "webcontrol-c.local" in the ad-
dress bar.
The screen interface jumps to the "Operation" menu item.
Commissioning
To Next Page
Loading...
Need help?
General
