Warmup WT01 - Sensor Calibration

PAGE 34
© 2014 OJ Electronics A/S
Sensor Calibration
This option allows you to calibrate the room sensor.
Calibration is only possible for the room sensor and only if “Room/Floor Limit” has
been chosen under “Sensor Application”.
If the temperature reading diers from the actual room temperature (measured with
a thermometer) you can calibrate the sensor with +/- 10°C in steps of 0.5°C in the
following way:
1. Tap the “Menu” button on the home screen.
Then tap the “Engineer Settings” button.
2. Scroll down and tap the “Sensor Calibration” button.
3. Confirm that you want to calibrate the sensor with “√” or cancel with “X”.
4. If “√” is chosen, you must then oset the thermostat to reflect the room tempera-
ture actually measured.
5. Use the “Up Arrow” or “Down Arrow” button to set the measured room tem-
perature.
6. Confirm the value with “OK”. A confirmation screen will be displayed briefly.
7. The thermostat will automatically return to “Engineer Settings”.