Hose 1: Install the Water Inlet Hose and Sprayer
The Water Inlet Hose needs to be connected to your water source at one end and to the water input
Push-to-connect fitting at the other end.
1. Find the Water Inlet Hose and Tee Connector: In your Accessory Kit, you will find a Water
Inlet Hose (3/8” diameter White Hose) and the Tee Connector with three ports
2. Connect the Input Check valve, Pressure Reducer and Sprayer hose to the Tee connector,
then push the whole assembly into the water input at the back of the WAZER Pro.
Note 3 Pg.17
Setting Up WAZER Pro |
SECTION 4
35
To Next Page
Loading...