Weber mt MC 85 - Page 10

10
Spare parts, changes
and conversions
Changes and conversions are prohibited unless made with original
WeberMTspareparts.Ifthemachineismodiedwithotheracces-
sories without the approval of Weber MT, the manufacturer will not
assume liability for any resulting personal injury or property damage.
All maintenance and repairs must be carried out with original
WeberMTspareparts.Untestedsparepartsmaya󰀨ectthe
reliability and safety of the machine.
Before starting
the machine
The machine must not be started unless the lock on the articulated
joint has been removed and stowed in the rear section of the machine.
If both halves of the machine are connected by the lock,
the operator will not be able to steer the machine.
The machine must not be started while maintenance or repairs
are pending.
The machine must not be started unless the operator is wearing
the required personal protective equipment.
The machine must not be started if loose objects have been placed
on top of it.
The machine must not be started unless the hoods have been closed.
The machine must not be started unless all safety devices have
been properly attached.
Start-up procedure
It is forbidden to disperse any sprays or other agents into the air
intake while the machine is starting up.
They may lead to overheating in the combustion chamber.
Before the machine can start, drive and steering lever must be in
theneutralpositionandthevibrationsystemmustbeswitchedo󰀨.
This prevents the machine from starting to move unexpectedly
during the start-up procedure.
Immediately following the start-up procedure, all control indicators
on the display of the remote control must go out. There may be
a technical defect if a warning remains. In this case, the engine
mustbeswitchedo󰀨andthecausemustbeidentiedandrectied.
Thereisdangerofsu󰀨ocationintheimmediatevicinityofthemachine
if the operator starts up the machine in closed rooms or in trenches.
Operating the machine in closed rooms is prohibited. An adequate
supply of air must be ensured before the machine is started.