Weber mt MC 85 - 8 Cleaning

33
Slow maneuvering Themachineo󰀨ersanoptionfordrivingataspeedslowerthan
operating speed for the purpose of loading the machine with
a ramp and for maneuvering it precisely.
Selectidlespeedusingthe“Enginespeed”selectorswitch.
Steer the machine using driving and steering commands.
The vibration is not available during driving at idle speed.
To prevent environmental pollution, cleaning tasks may
only be executed in areas that are suitable and have been
approved for this purpose (e.g. drain with oil separator).
8. Cleaning
Cleaning agent
The recommended option for cleaning the machine daily at
the end of work is to use a simple jet of water. The top section
must not be cleaned with a high-pressure cleaner.
If the engine or other components are supposed to be cleaned
thoroughly, e.g. before scheduled maintenance, it is recommended
to use a customary cold cleaning agent.
Cleaning the radio
remote control
Remove the radio remote control from its compartment.
It must not be cleaned with a high-pressure cleaner.
Never aim directly into the openings of the machine.
To deep clean the engine, spray it with customary cold cleaning
agentandrinseito󰀨afterwards.Followtheinstructionof
the cleaning agent’s manufacturer.
Wipe the radio remote control with a damp cloth and allow it
to dry afterwards.
The radio remote control must not be cleaned with a high-
pressure cleaner.
Center of gravity
When lifting and securing the machine on a transport vehicle, observe
position number 3 as it indicates the position of the center of gravity.