Weber mt MC 85 - Operating Positions on the Machine

18
1
2
3
B 1001-0120
5.2. Operating positions on the machine
1 The radio remote control The radio remote control is used to control the machine. It is
explainedinmoreretailinthesection“Theradioremotecontrol”.
2 The key switch The key switch is used to switch the power supply to the machine
onoro󰀨.
Switchinposition“I”(ON)
Power is switched on.
Switchinposition“0”(OFF)
Powerisswitchedo󰀨.
Failuretoswitcho󰀨thepowerafterworkhasbeenconcludedmaydrain
the starter battery.
Therefore,alwayssetthekeyswitchtothe“0”(OFF)positionafterwork
has been concluded.
3 The charger for the
radio remote control
The charger is used to charge the battery of the radio remote control.
It is described in more detail in the section “Replacing and charging
thebattery”.