Weber mt MC 85 - 4 Safety

8
General All safety instructions must be read and complied with,
as non-compliance will result in
– Danger to life and limb of the user,
– Impairments to the machine or other property.
In addition to the operating manual, the accident-prevention regulations
in the country where the appliance is used must be complied with.
Intended use The roller should only be used in technically faultless condition,
as intended, in a safety-conscious and hazard-conscious manner,
and in compliance with the instructions in the operating manual.
Malfunctions that impair safety must be eliminated without delay.
The MC 85 roller is designed exclusively for the following operations:
– Compacting work during the construction of channels
and pipes
 –Structurebacklling
– Compacting operations during railroad and dam construction
– Compressing cohesive ground for the construction of trenches
– Compaction of substructures and foundations
The operator’s work position is behind the machine.
If changing their position, the operator must keep in mind that
the directions of the control levers only match the movements of
the roller as seen from behind the roller.
Non-intended use Unless used as intended, the machine involves a risk of personal
injury and property damage. The machine is expressly not
suitable for:
– Transporting people or material.
– Operation of the machine in non-compliance with the warn-
ings provided on the machine and in the operating manual.
– Towing other machines or equipment.
– Travel over frozen subsurfaces.
– Travel over concrete or bituminous surfaces.
– Travel over sloping or unsound ground.
– Operation without visual contact.
 –Useofthemachinewithnon-operationalprotectivextures.
– Operation of the machine in an explosive atmosphere.
The responsibility for any damage arising from non-intended use
falls on the owner / operator rather than the manufacturer.
Residual risk There is always an increased risk of accidents in the danger area
of the machine.
Anyone close to the machine must be made aware of this risk
to allow them to react promptly in the event of a malfunction by
paying increased attention and to minimize the risk of injury.
4. Safety