Weber mt MC 85 - Shut-Off Devices

26
6.2. Shut-o󰀨 devices
The near-eld
shutdown system
Theradiosystemisequippedwithanear-eldshutdownsystem.
If the operator holding the radio remote control moves up to the
machine closer than 2 meters, the machine will stop all driving and
steering commands and the vibration. The display of the remote control
indicates in which area the minimum distance was not observed.
In this case:
The remote
shutdown system
Use the drive lever to steer in the opposite direction
OR
Set the drive lever to the neutral position and
Step out of the safety area.
Operation can resume.
Inadditiontoanear-eldshutdownsystem,themachinealso
comes with a remote shutdown system. The remote shutdown
system operates in two stages.
If the operator holding the radio remote control moves away from
the machine farther than 20 meters, the machine will stop all driving
and steering commands and the vibration. The display of the radio
remote control shows the corresponding symbol (section 6.5).
Inthiscase,proceedasdescribedunder“Thenear-eldshutdown
system”toresumeoperation.
Since the machine can also not receive an emergency stop command
in the event of a radio signal disruption, the engine will be switched
o󰀨iftheradiosignalisdisruptedorifthedistancetothemachine
is greater than 100 meters.
In this case:
Step closer to the machine.
If necessary, rectify the cause for the disruption of the signal.
Restart the machine.
Rollover protection
If the machine tips over despite the use of utmost caution,
care must be taken to prevent damage to the engine.
Ifthemachinetiltsfurtherthan45°,theengineswitcheso󰀨to
ensure safety.
If lying on its side, the machine may allow oil to enter the
combustion chamber of the engine. If started in this case,
the engine may sustain severe damage. Therefore, move the
machine back into an upright position as quickly as possible,
but also in accordance with the safety guidelines.
After tipping over, the machine must not be restarted until it has
been ensured that there is no more oil in the combustion chamber
of the engine.
Contact an authorized dealer in this regard.